API Guide

Version Description
9.9(0.0) Introduced on the C9010.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.1 Introduced on the S4810.
E-Series legacy
command
Usage Information
After you enable multicast, you can enable IGMP and PIM on an interface. In INTERFACE mode, enter the ip
pim sparse-mode command to enable IGMP and PIM on the interface.
Related
Commands
ip pim sparse-mode — enables IGMP and PIM on an interface.
show ip multicast-cam
Display the content addressable memory (CAM) size and the portions allocated for IP multicast traffic.
Syntax
show ip multicast-cam linecard slot-id port-set port-pipe
Parameters
linecard slot-id Enter the keyword linecard with a slot number to select the line card for which to
gather information. The range of Z9500 slot IDs is from 0 to 2.
port-set port-pipe Enter the keyword port-set with a port-pipe number to select the port pipe for which
to gather information. The range of port pipes is from 0 to 3.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.1 Introduced on the S4810.
E-Series legacy
command
Multicast 1035