Users Guide

Version Description
9.12(1.0) Introduced on the S5048F–ON.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Introduced
Usage
Information
This command applies to any physical interface with speed set to 10/100.
NOTE: Starting with Dell EMC Networking OS version 7.8.1.0, when you use a copper SFP2 module
with catalog number GP-SFP2-1T in the S25P model of the S-Series, you can manually set its speed
with the speed command. When you set the speed to 10 Mbps or 100 Mbps, you can also execute
the duplex command.
Related
Commands
● negotiation auto — enable or disables auto-negotiation on an interface.
disable stack-unit phy temp polling
Disable physical temperature polling for 10GBase-T optical ports.
Syntax
disable stack-unit unit-number port port-number phy temp polling
To enable physical temperature polling, use the enable stack-unit unit-number port port-
number phy temp polling command.
Parameters
stack-unit unit-
number
Enter the keyword stack-unit then the unit-numberfor which you want to
disable temperature polling. The range is from 1 to 6.
port port-number Enter the keyword port then the port-number for which you want to disable
temperature polling. The range is from 1 to 48.
Defaults Enabled
Command Modes EXEC
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14(0.0) Introduced on the S4048–ON and S5048F-ON.
662 Interfaces