Users Guide

Version Description
7.7.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Example
DellEMC(conf-mon-sess-1)# show config
!
monitor session 1
source twentyFiveGigE 1/1 destination Port-channel 1 direction rx
show monitor session
Display information about monitoring sessions.
Syntax
show monitor session {session-ID} [access-list]
To display monitoring information for all sessions, use the show monitor session command.
Parameters
session-ID (OPTIONAL) Enter a session identification number. The range is from 0 to 65535.
[access-list] (OPTIONAL) Enter the access-list keyword to display the ACLs applied to
monitor sessions.
Defaults none
Command Modes
● EXEC
● as
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14(0.0) Updated to display the IPv6 ACLs applied to monitor session on the S6000,
S6000–ON, S5048F-ON, S6100–ON, and Z9100–ON.
9.12(1.0) Introduced on the S5048F–ON.
9.12(0.0) Introduced the access-list optional keyword to display the ACLs applied to
monitor sessions on the S6000, S6100–ON and Z9100–ON.
9.11(0.0) Introduced the support for GRE Protocol and FC Monitor in the command output.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.4.0.0 Added support for the RPM / ERPM.
9.0.2.0 Introduced on the S6000.
1204 Port Monitoring