Deployment Guide

Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.5.1.0 Introduced on the E-Series.
mac port-security
Enable or disable the port security feature globally in the system.
Syntax
mac port-security
To disable the port security, use the no mac port-security command.
Defaults Enabled
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14(1.0) Introduced on the C9010, MXL, FN IOM, S3100 series, S4810, S4820T, S3048–ON,
S4048–ON, S4048T-ON, S5048F-ON, S6000, S6000–ON, S6010–ON, S6100–ON,
Z9100–ON, and Z9500.
Usage
Information
Only if you enable the port security, you will be able to configure MAC address learning limit
configurations on the interface level.
When you disable the port security, all the interface level configurations are reset. Also, all dynamically
learnt MAC addresses on the interfaces configured with MAC address learning limit are cleared.
show cam mac stack-unit
Display the content addressable memory (CAM) size and the portions allocated for MAC addresses and for MAC ACLs.
Syntax
show cam mac stack-unit unit_number port-set port-pipe count [vlan vlan-id]
[interface interface]
Parameters
stack-unit
unit_number
(REQUIRED) Enter the keyword stack-unit followed by a stack member number
to select the stack unit. The range is from 1 to 12.
port-set port-
pipe
(REQUIRED) Enter the keywords port-set followed by a Port-Pipe number to
select the Port-Pipe.
address mac-
addr
(OPTIONAL) Enter the keyword address followed by a MAC address in the
nn:nn:nn:nn:nn:nn format to display information on that MAC address.
dynamic (OPTIONAL) Enter the keyword dynamic to display only those MAC addresses
learned dynamically by the switch.
static (OPTIONAL) Enter the keyword static to display only those MAC address
specifically configured on the switch.
Layer 2 883