Deployment Guide

Name servers are not set
Host Flags TTL Type Address
-------- ----- ---- ---- -------
ks (perm, OK) - IP 2.2.2.2
4200-1 (perm, OK) - IP 192.68.69.2
1230-3 (perm, OK) - IP 192.68.99.2
ZZr (perm, OK) - IP 192.71.18.2
Z10-3 (perm, OK) - IP 192.71.23.1
DellEMC#
Related
Commands
● traceroute — view the DNS resolution.
● ip host — configure a host.
show ip cam stack-unit
Display CAM entries for a port-pipe of a stack-unit on a S-Series or Z-Series switch.
Syntax
show ip cam stack-unit {stack-unit-number} [port-set {pipe-number} | vrf
vrf-name {ip-address mask [longer-prefixes [ecmp-group detail]]}| ecmp-
group {detail | member-info [detail [group-index index-number]]}| summary]
Parameters
stack-unit-
number
Enter the stack-unit ID. The range is from 1 to 12.
port-set pipe-
number
Enter the keyword port-set then the number of the stack unit’s port-pipe. The
unit ID range is from 0 to 0.
vrf vrf-name Enter the keyword vrf followed by the name of the VRF to display CAM entries
corresponding to that VRF.
network mask
[longer-prefixes
[ecmp-group
detail]]
(OPTIONAL) Enter the IP address and mask of a route to CAM entries for that
route only. You can enter one of the following keywords to filter results.
● Enter the keyword longer-prefixes to view routes with a common prefix.
● Enter the keyword ecmp-group detail to view the ECMP group index.
ecmp-group
{detail | member-
info [detail
[group-index
index-number ]]}
(OPTIONAL) Enter the keyword ecmp-group then one of the following keywords
to filter results.
● Enter the keyword detail to view the ECMP group index.
● Enter the keyword member-info to view the member information for the
ECMP group.
● Enter the keyword member-info detail to view detailed ECMP
membership and n-hop information.
● Enter the keyword group-index then the index number to show ECMP
membership per group. The range is from 0 to 1022.
summary (OPTIONAL) Enter the keyword summary to view a table listing route prefixes and
the total number routes which can be entered in to CAM.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Increased the stacking range to 12 units in S3100 series.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
742 IPv4 Routing