CLI Guide

Version Description
E-Series Original command.
Usage
Information
Users entering EXEC Privilege mode or any other configured privilege level can access configuration
commands. To protect against unauthorized access, use the enable password command to configure
a password for the enable command at a specific privilege level. If no privilege level is specified, the
default is privilege level 15.
NOTE: If you are authorized for the EXEC Privilege mode by your role, you do not need to enter an
enable password.
Related
Commands
● enable password — configures a password for the enable command and to access a privilege level.
enable optic-info-update interval
Enable polling intervals of optical information updates for simple network management protocol (SNMP).
Syntax
enable optic-info-update [interval seconds]
To disable optical power information updates, use the no enable optic-info-update interval
command.
Parameters
interval seconds Enter the keyword interval then the polling interval in seconds. The range is
from 120 to 6000 seconds. The default is 300 seconds (5 minutes).
Defaults Disabled
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Replacement command for the S4820T. Replaces the enable xfp-power-
updates command.
8.3.11.4 Replacement command for the Z9000. Replaces the enable xfp-power-
updates command
8.3.10.0 Replacement command for the S4810 only. Replaces the enable xfp-power-
updates command.
Usage
Information
To enable polling and to configure the polling frequency, use this command.
92 Control and Monitoring