CLI Guide

State Machine Type is Feature
Conf TLV Tx Status is enabled
23 Input Conf TLV Pkts, 47 Output Conf TLV Pkts, 0 Error Conf TLV Pkts
DCBX Commands
The following DCBX commands are supported on the Dell EMC Networking OS.
advertise dcbx-tlv
On a DCBX port with a manual role, configure the PFC and ETS TLVs advertised to DCBX peers.
Syntax
advertise dcbx-tlv {ets-conf | ets-reco | pfc} [ets-conf | ets-reco | pfc]
[ets-conf | ets-reco | pfc]
To remove the advertised ETS TLVs, use the no advertise dcbx-tlv command.
Parameters
{ets-conf | ets-
reco | pfc}
Enter the PFC and ETS TLVs advertised, where:
● ets-conf: enables the advertisement of ETS configuration TLVs.
● ets-reco: enables the advertisement of ETS recommend TLVs.
● pfc: enables the advertisement of PFC TLVs.
Defaults All PFC and ETS TLVs are advertised.
Command Modes PROTOCOL LLDP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON and Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
You can configure the transmission of more than one TLV type at a time; for example: advertise
dcbx-tlv ets-conf ets-reco.
You can enable ETS recommend TLVs (ets-reco) only if you enable ETS configuration TLVs (ets-
conf). To disable TLV transmission, use the no form of the command; for example, no advertise
dcbx-tlv pfc ets-reco.
DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.
Configure DCBX operation at the INTERFACE level on a switch or globally on the switch. To verify the
DCBX configuration on a port, use the show interface dcbx detail command.
Data Center Bridging (DCB) 483