Users Guide

Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.4.1.0 Added support for port-channel interfaces (the port-channel number option).
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.7.1.0 Added the backup interface option.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0
Introduced on the E-Series.
Usage
Information
If an IP address or VRRP group is assigned to the interface, you cannot use the switchport command
on the interface. To use the switchport command on an interface, only the no ip address and no
shutdown statements must be listed in the show config output.
When you enter the switchport command, the interface is automatically added to the default VLAN.
To use the switchport backup interface command on a port, first enter the switchport
command. For more information, see “Configuring Redundant Links” in the Layer 2 section in the Dell
EMC Networking OS Configuration Guide.
wavelength
Set the wavelength for tunable 10–Gigabit SFP+ optics.
Syntax
wavelength
To retain the existing wavelength, use the no wavelength command.
Defaults none
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6000, S6000–ON, S5000, S4810, S4820T, S3048–ON,
S4048–ON, M I/O Aggregator, FN I/O Module, MXL, C9010, S3100 series, and
Z9100-ON.
Usage
Information
The wavelength can be configured only on a tunable 10–Gigabit SFP+ optic. The wavelength range is
from 1528.3 nm to 1568.77nm.
740 Interfaces