Users Guide

Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S-Series.
Usage
Information
A new policy command is introduced in order to attach the Link Bandwidth extended community only
to the prefixes that are received from a neighbor that satisfy the desired conditions. This command is
relevant for both inbound as well as outbound policy handling (for received prefixes). Also, there is no
change to the set of supported conditions or filters.
During configuration, the bandwidth is specified in Mbps, not in bytes/second. While creating the actual
LB extended community, the system will attach the AS number and encode the bandwidth in floating
point format.
show capture bgp-pdu neighbor
Display BGP packet capture information for an IPv4 address on the system.
Syntax
show capture bgp-pdu neighbor ipv4-address
Parameters
ipv4-address Enter the IPv4 address (in dotted decimal format) of the BGP address to display
packet information for that address.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.5.1.0 Introduced.
Example
DellEMC(conf-router_bgp)# show capture bgp-pdu neighbor 20.20.20.2
Incoming packet capture enabled for BGP neighbor 20.20.20.2
Border Gateway Protocol 419