Users Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

1741

Table Of Contents

Parameters

instance ID

Enter the VXLAN instance ID. The platform supports only the instance ID 1 in the

initial release.

static Enter the keyword static to set the VXLAN instance in static mode.

Defaults Controller mode.

Command Modes CONFIGURATION

Command

History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

EMC Networking OS Command Line Reference Guide.

Version Description

9.11(0.0) Introduced on the S4048–ON, S4048T-ON, S6000–ON, S6010–ON, S6100–ON,

and Z9100–ON.

Usage

Information

By default, VXLAN instance is created in controller mode. You need a controller to configure VTEP. When

you create VXLAN instance in static mode, you can configure VTEP through CLIs.

Use the no shutdown command to enable the VXLAN instance.

Only one VXLAN instance can exist in a system.

You cannot modify a VXLAN instance mode. If you need to change the mode, you can delete the existing

VXLAN instance and create a new instance with the required mode.

Example

Enable VXLAN instance:

DellEMC(conf)#feature vxlan

DellEMC(conf)#vxlan-instance 1 static

DellEMC(conf-vxlan-inst-1)#no shutdown

Disable VXLAN instance:

DellEMC(conf)#no vxlan-instance 1 static

vxlan-vnid

Associate VNID to VLAN.

Syntax

vxlan-vnid VNID

To remove the association, use the no vxlan-vnid command.

Parameters

VNID

Enter the logical network identifier.

Defaults None

Command Modes INTERFACE VLAN