Users Guide

debug vxlan
Debug messages between the Gateway and Controller.
Syntax
debug vxlan
Defaults Disabled
Command Modes EXEC Privilege
Command
History
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100–ON.
9.10(0.1P10) Introduced on the Z9100–ON.
9.8(0.0) Introduced on the S4048–ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Introduced on the S6000.
disable-mac-learn
Disable MAC address learning on the network port of a static VXLAN tunnel.
Syntax
disable-mac-learn remote-vtep-ip
To return to the default state of enabled, use the no disable-mac-learn command.
Parameters
remote-vtep-ip Enter the IP address of the remote VTEP that connects to the VXLAN tunnel on
which MAC learning should be disabled.
NOTE: The remote VTEP should already be configured.
Defaults Enabled
Command Modes VXLAN-INSTANCE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command-Line Reference Guide.
Version Description
9.14(2.3) Introduced on the S4048–ON, S4048T-ON, S6000, S6010-ON, S6100-ON, and
Z9100–ON.
Usage
Information
Use the disable-mac-learn command in the VXLAN-INSTANCE mode.
NOTE:
● This command is only applicable for static VXLAN and does not work for the other modes of
VXLAN (controller and nuage).
● The remote VTEP should already be configured.
● In case of static VXLAN VLT deployments, this configuration should be symmetric across VLT
nodes.
Virtual Extensible LAN (VXLAN) 1737