Setup Guide

Version Description
9.11(3.0) Introduced on the S3048–ON, S4048–ON, S4048T-ON, S6000–ON, S6010–ON,
S6100–ON, Z9100–ON, S3100, and C9010.
debug ipv6 mld
Enable debugging on IPv6 MLD packets.
Syntax
debug ipv6 mld [vrf vrf-name] {group-address | interface}
To turn off debugging, use the no debug ipv6 mld {group-address | interface} command.
Parameters
vrf vrf-name (Optional) Enter the keyword vrf followed by the name of the VRF.
group-address (OPTIONAL) Enter the multicast group address in the x:x:x:x::x format. The ::
notation specifies successive hexadecimal fields of zero.
interface Enter the following keywords and slot/port or number information:
● For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
followed by the slot/port information.
● For a Port Channel interface, enter the keywords port-channel then a
number.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port/subport information.
● For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE
then the slot/port/subport information.
● For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the
slot/port/subport information.
● For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then
the slot/port/subport information.
● For a VLAN, enter the keyword vlan followed by a number from 1 to 4094.
Defaults Disabled.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.11(3.0) Introduced on the S3048–ON, S4048–ON, S4048T-ON, S6000–ON, S6010–ON,
S6100–ON, Z9100–ON, S3100, and C9010.
ipv6 mld explicit-tracking
Enable MLD explicit tracking receivers.
Syntax
ipv6 mld explicit-tracking
To disable explicit tracking, use the no ipv6 mld explicit-tracking command.
Defaults Disabled.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Multicast Listener Discovery Protocol 961