Setup Guide

Version Description
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command
Usage
Information
After entering the banner login command, type one or more spaces and a delineator character. Enter the
banner text then the second delineator character. When the user is connected to the router, if a message
of the day banner is configured, it displays first. If no message of the day banner is configured, the login
banner and prompt appear. After the user has logged in, the banner EXEC (if configured) displays.
Related
Commands
● banner exec — enables the display of a text string when you enter EXEC mode.
● banner login — sets a banner to display after successful login to the system.
boot-type
Allows you to configure the boot-type for the next reload.
Syntax
boot-type bmp reload| fastboot| normal-reload| warmboot
Parameters
bmp-reload Reloads using the bare metal provisioning mode
fastboot Reloads using the fastboot mode
normal-reload Reloads using the standard, manual interactive mode
warmboot Reloads using the warmboot mode
Defaults normal-reload
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.12(0.0) Introduced on the S6000, S6100–ON and Z9100–ON
Usage
Information
Once you enter reload-type, you need to enter the boot-type required on the next reboot. After
configuring boot-type you need to save the configuration with the write cli to make it active.
Example
DellEMC(conf-reload-type)#boot-type warmboot
DellEMC(conf-reload-type)#end
Dell#
cam-acl
Allocate content addressable memory (CAM) for IPv4 and IPv6 ACLs.
Syntax
cam-acl {default | l2acl number ipv4acl number ipv6acl number ipv4qos
number l2qos number l2pt number ipmacacl number [vman-qos | vman-dual-qos]
number {fcoeacl number} {openflow {4|8}}
Parameters
default Use the default CAM profile settings and set the CAM as follows:
● L2Acl : 2
● Ipv4Acl : 2
88 Control and Monitoring