Setup Guide

Usage
Information
If an IP address or VRRP group is assigned to the interface, you cannot use the switchport command
on the interface. To use the switchport command on an interface, only the no ip address and no
shutdown statements must be listed in the show config output.
When you enter the switchport command, the interface is automatically added to the default VLAN.
To use the switchport backup interface command on a port, first enter the switchport
command. For more information, see “Configuring Redundant Links” in the Layer 2 section in the Dell
EMC Networking OS Configuration Guide.
wavelength
Set the wavelength for tunable 10–Gigabit SFP+ optics.
Syntax
wavelength
To retain the existing wavelength, use the no wavelength command.
Defaults none
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6000, S6000–ON, S5000, S4810, S4820T, S3048–ON,
S4048–ON, M I/O Aggregator, FN I/O Module, MXL, C9010, S3100 series, and
Z9100-ON.
Usage
Information
The wavelength can be configured only on a tunable 10–Gigabit SFP+ optic. The wavelength range is
from 1528.3 nm to 1568.77nm.
If you configure the wavelength on a non-tunable optic, there is no change to the existing wavelength.
The configured wavelength is saved in the running configuration and is applicable, when a tunable optic is
used.
If you do not configure the wavelength on an inserted tunable optic, the existing wavelength is used.
Example
The following example shows the wavelength set for a tunable 10–Gigabit SFP+ optic:
DellEMC(conf-if-te-1/1/1)# wavelength 1528.30
Related
Commands
● show config — displays the interface configuration.
Port Channel Commands
A Link Aggregation Group (LAG) is a group of links that appear to a MAC client as if they were a single link according to IEEE
802.3ad. In Dell EMC Networking OS, a LAG is referred to as a Port Channel.
● The platform supports 4096 port channels and 16 members per port channel.
As each port can be assigned to only one Port Channel, and each Port Channel must have at least one port, some of those
nominally available Port Channels might have no function because they could have no members if there are not enough ports
installed.
NOTE:
The Dell EMC Networking OS implementation of LAG or Port Channel requires that you configure a LAG on both
switches manually. For information about Dell EMC Networking OS link aggregation control protocol (LACP) for dynamic
LAGs, refer to the Link Aggregation Control Protocol (LACP) chapter. For more information about configuring and using
Port Channels, refer to the Dell EMC Networking OS Configuration Guide.
Interfaces 709