Setup Guide

Usage
Information
When you enter the reload command and the system reboots, you will not be prompted for a password
to enter the EXEC Privilege mode (normally you are required to enter the enable command).
If your console or Telnet session expires after you used the ignore enable-password command, you are
prompted for an enable password when you re-establish the session
Related
Commands
reload — Exit from this mode and reload FTOS.
ignore startup-config
During a reload, do not load the startup-config file.
Syntax ignore startup-config
Defaults disabled
Command Modes BOOT_USER
Command
History
Version Description
9.10(0.0) Introduced on the S6100.
9.8(1.0) Introduced on the Z9100–ON.
9.0.2.0 Introduced on the S6000.
Usage
Information
Use this command if you have authentication procedures in the startup-config other than the enable-
password setting.
interface management ethernet ip address
Assign an IP address to the Management Ethernet interface.
Syntax
[no] interface management ethernet ip address ip-address mask
To delete the IP address, enter no interface management ethernet ip address.
Defaults Not configured.
Command Modes BOOT_USER
Command
History
Version Description
9.10(0.0) Introduced on the S6100.
9.8(1.0) Introduced on the Z9100–ON.
9.0.2.0 Introduced on the S6000.
Usage
Information
In the runtime CLI, use the ip address command in INTERFACE mode to change the Management
interface’s IP address.
To view the current IP address configured on the Management interface, enter the show interfaces
management ethernet command
Related
Commands
show_default-gateway — Display the IP address configured for the default gateway.
show_interface_mangement_ethernet— Display the IP address configured for the Management
interface.
330 Boot Command Line Interface