Setup Guide

Version Description
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
7.6.1.0 Introduced on the C-Series and S-Series.
7.4.1.0 Introduced on the E-Series.
Usage
Information
The authenticator completes authentication only when you set port-control to auto.
dot1x profile
Configure a dot1x profile to define a list of trusted supplicant MAC addresses.
Syntax
[no] dot1x profile profile-name
Parameters
profile-name Enter a dot1x profile-name. The profile name length is limited to 32 characters.
Defaults None
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Error Strings NONE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S3100 series, S4048–ON, S4048–ON, S4810, S4820T, S5000,
S6000, S6000–ON, S6100–ON, the Configuration Terminal Batch mode on C9010,
Z9100–ON, and Z9500.
9.9(0.0) Introduced on the C9010.
Usage
Information
The dot1x profile command configures a dot1x profile to define a list of trusted supplicant MAC
addresses. Maximum number of dot1x profiles is limited to 10. This command launches dot1x profile mode
for entering profile related commands such as the mac command. The dot1x static-mab command
assigns the dot1x profile to an interface.
Use this command in Configuration Terminal Batch mode to configure the dot1x profile in a dual-homing
setup.
170 802.1X