Setup Guide

Version Description
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage
Information
You can configure both IPv4 and IPv6 virtual addresses simultaneously, but only one of each. Each time
this command is issued, it replaces the previously configured address of the same family, IPv4 or IPv6.
The no virtual-ip command takes an address/prefix-length argument, so that the desired address
only is removed. If you enter the no virtual-ip command without any specified address, then both
IPv4 and IPv6 virtual addresses are removed.
Related
Commands
● ip address — assigns a primary and secondary IP address to the interface.
warmboot-failure-action
This CLI is used to define the system behavior in the event of a warmboot failure.
Syntax
warmboot-failure-action fastboot| normal-reload
Parameters
fastboot Do a fastboot on warmboot failure
normal-reload Do a normal reload on warmboot failure
Defaults normal-reload
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.12(0.0) Introduced on the S6000, S6100–ON and Z9100–ON
Usage
Information
Enter warmboot-failure-action fastboot to restart in fastboot mode in case there is a failure
of warmboot. Enter warmboot-failure-action normal-reload to restart in normal mode in case
there is a failure of warmboot.
write
Copy the current configuration to either the startup-configuration file or the terminal.
Syntax
write [memory [compressed] | terminal]
Parameters
memory Enter the keyword memory to copy the current running configuration to the
startup configuration file. This command is similar to the copy running-config
startup-config command.
compressed Enter the keyword compressed to write the operating configuration to the
startup-config file in the compressed mode.
156 Control and Monitoring