Setup Guide

Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 6.2.1.1 Introduced on the E-Series.
Related
Commands
● ip poison-reverse — sets the prefix for RIP routing updates.
maximum-paths
Set RIP to forward packets over multiple paths.
Syntax
maximum-paths number
To return to the default values, use the no maximum-paths commands.
Parameters
number Enter the number of paths. The range is from 1 to 16. The default is 4 paths.
Defaults 4
Command Modes ROUTER RIP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
Routing Information Protocol (RIP) 1293