Setup Guide

Example
DellEMC# show monitor session 1
SessID Source Destination Dir Mode Source IP
Dest IP DSCP TTL Drop Rate Gre-Protocol FcMonitor
------ ------ ----------- --- ---- ---------
-------- ---- --- ---- ---- ----------- ---------
1 Te 1/2/1 remote-ip rx Port 0.0.0.0
0.0.0.0 0 0 No N/A N/A yes
DellEMC#
DellEMC# show monitor session
SessID Source Destination Dir Mode Source IP
Dest IP DSCP TTL Drop Rate Gre-Protocol FcMonitor
------ ------ ----------- --- ---- ---------
-------- ---- --- ---- ---- ----------- ---------
1 Te 1/2/1 remote-ip rx Port 0.0.0.0
0.0.0.0 0 0 No N/A N/A yes
DellEMC#
Example (show
monitor session
access-list)
The following is an example output of the show monitor session access-list command.
DellEMC#sho monitor session 13 access-list
Monitor session – 13
Interface Direction Mirror-access-list
--------- --------- ------------------
Te 1/1/1 rx mtacl
mtv6acl(ipv6)
Related
Commands
● monitor session — creates a monitoring session.
● rate-limit — configures the rate-limit.
show running-config monitor session
Display the running configuration of all monitor sessions or a specific session.
Syntax
show running-config monitor session {session-ID}
To display the running configuration for all monitor sessions, use the show running-config
monitor session command.
Parameters
session-ID (OPTIONAL) Enter a session identification number. The range from 0 to 65535.
Defaults none
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
1200 Port Monitoring