Install Guide

● Include directly connected or user-configured (static) routes into BGP.
ROUTER BGP or CONF-ROUTER_BGPv6_ AF mode
redistribute {connected | static} [route-map map-name]
Configure the following parameters:
○ connected: Indicate that you are redistributing routes to directly connected routes into BGP.
○ static: Indicate that you are redistributing static routes into BGP.
○ route-map map-name: Specify the name of a configured route map to be consulted before adding the connected or
static route.
● Include specific ISIS routes into BGP.
ROUTER BGP or CONF-ROUTER_BGPv6_ AF mode
redistribute isis [level-1 | level-1-2 | level-2] [metric value] [route-map map-name]
Configure the following parameters:
○ isis: Indicate that you are redistributing ISIS routes into BGP.
○ level-1, level-1-2, or level-2: Assign all redistributed routes to a level. The default is level-2.
○ metric value: The value is from 0 to 16777215. The default is 0.
○ route-map map-name: Specify the name of a configured route map to be consulted before adding the ISIS route.
● Include specific OSPF routes into BGP.
ROUTER BGP or CONF-ROUTER_BGPv6_ AF mode
redistribute ospf process-id [match external {1 | 2} | match internal] [metric-type
{external | internal}] [route-map map-name]
Configure the following parameters:
○ ospf: Indicates that you are redistributing OSPF routes in BGP.
○ process-id: the range is from 1 to 65535.
○ match internal, external1, and external2: Specify the type of OSPF routes to be redistributed into BGP.
○ metric-type: external or internal.
○ route-map map-name: Specify the name of a configured route map to be consulted before adding the OSPF route.
DellEMC# configure terminal
DellEMC(conf)# ip route 10.0.0.0 255.0.0.0 null 0
DellEMC(conf)# router bgp 400
DellEMC(conf-router_bgp_af)# redistribute static
DellEMC(conf-router_bgp_af)# exit
The above configuration example show how to create a static route and redistribute the static routes into the BGP routing
table.
Enabling Additional Paths
The additional path allows the advertisement of more paths in addition to the best path. Enabling additional path allows the
advertisement of multiple paths for the same address prefix without the new paths replacing any previous paths. The additional
path feature is disabled by default.
NOTE: Dell EMC Networking OS recommends not to use multipath and add path simultaneously in a route reflector.
To allow multiple paths sent to peers, use the following commands.
1. Allow the advertisement of multiple paths (send, receive or both).
CONFIG-ROUTER-BGP or CONFIG-ROUTER-BGP-AF mode
bgp add-path [both | enable | receive | send] path-count
Configure the following parameters:
● both: Indicate that the system sends and accepts multiple paths from peers.
● enable: Indicate that the system enables add-path support for the node.
Border Gateway Protocol (BGP)
175