Deployment Guide

Table 69. Create a Rule for a Redirect-list (continued)
operators — For TCP and UDP
parameters only. Enter one of the
following logical operand:
● eq = equal to
● neq = not equal to
● gt = greater than
● lt = less than
● range = inclusive range of ports (you
must specify two ports for the port
command parameter.)
source ip-address or any or host
ip-address (Optional) — Source’s IP
address or host from which they packets
were sent.
mask (Optional) — network mask /
prefix format (/x).
any (Optional) — Specifies that all
traffic is subject to the filter.
destination mask — IP address of the
network or host to which the packets
are sent.
FORMAT: A.B.C.D/NN, or ANY or HOST
IP address
Below is an example:
Dell(conf-redirect-
list)#redirect 1.1.1.1
tcp an any ?
ack
Match on the ack bit
eq
Match only packets
on a given port number
fin
Match on the fin bit
gt
Match only packets
with a greater port number
lt
Match only packets
with a lower port number
neq
Match only packets
not on a given port number
psh
Match on the psh bit
range
Match only packets in
the range of port numbers
rst
Match on the rst bit
syn
Match on the syn bit
urg
Match on the urg bit
cr
Dell(conf-redirect-
list)#redirect 1.1.1.1
udp any any ?
eq
Match only packets
Policy-based Routing (PBR)
687