Deployment Guide

Use the following command in CONFIGURATION REDIRECT-LIST mode to set the rules for the redirect list. You can enter
the command multiple times and create a sequence of redirect rules. Use the seq nn redirect version of the command to
organize your rules.
Table 69. Create a Rule for a Redirect-list
Command Syntax Command Mode Purpose
{seq sequence-number}
redirect {ip-address| tunnel
tunnel-id} [track obj-id]
{protocol-type} {source mask
| any | host ip-address}
{destination mask | any
| host ip-address} [bit]
[operators]}
REDIRECT-LIST Configure a rule for the redirect list.
ip-address is the forwarding router’s
address
tunnel — keyword to configure the
tunnel settings.
tunnel-id is used to redirect the traffic.
Protocol-type — Enter one of the
following keywords as the protocol type
● icmp for Internet Control Message
Protocol
● ip for Any Internet Protocol
● tcp for Transmission Control Protocol
● udp for User Datagram Protocol
Optional
sequence-number (Optional) —
Configures a rule with an assigned
sequence number for the redirect list.
Enter a number from 1 to 65535.
track — keyword to enable tracking.
track <obj-id> is used to track the
object-id for a host reachability track
object. Enter a number from 1 to 500.
The track object should correspond to
the host tracking of the forwarding
router’s IP address configured in this
rule.
ip-protocol-number or protocol-type is
the type of protocol to be redirected
FORMAT: 0-255 for IP protocol number,
or enter protocol type (Optional):
● icmp — Internet Control Message
Protocol
● ip — Any Internet Protocol
● tcp — Transmission Control Protocol
● udp — User Datagram Protocol
bit — (Optional) For TCP protocol type
only, enter one or a combination of the
following TCP flags:
● ack = acknowledgement
●
fin = finish (no more data from the
user)
● psh = push function
● rst = reset the connection
● yn = synchronize sequence numbers
● urg = urgent field
686
Policy-based Routing (PBR)