Deployment Guide

applied to a command, such as redistribute, traffic passes through all instances of that route map until a match is found.
The following is an example with two instances of a route map.
Dell#show route-map
route-map zakho, permit, sequence 10
Match clauses:
Set clauses:
route-map zakho, permit, sequence 20
Match clauses:
interface TengigabitEthernet 0/1
Set clauses:
tag 35
level stub-area
Dell#
To delete all instances of that route map, use the no route-map map-name command. To delete just one instance, add the
sequence number to the command syntax.
Dell(conf)#no route-map zakho 10
Dell(conf)#end
Dell#show route-map
route-map zakho, permit, sequence 20
Match clauses:
interface TengigabitEthernet 0/1
Set clauses:
tag 35
level stub-area
Dell#
The following example shows a route map with multiple instances. The show config command displays only the configuration
of the current route map instance. To view all instances of a specific route map, use the show route-map command.
Dell#show route-map dilling
route-map dilling, permit, sequence 10
Match clauses:
Set clauses:
route-map dilling, permit, sequence 15
Match clauses:
interface Loopback 23
Set clauses:
tag 3444
Dell#
To delete a route map, use the no route-map map-name command in CONFIGURATION mode.
Configure Route Map Filters
Within ROUTE-MAP mode, there are match and set commands.
● match commands search for a certain criterion in the routes.
● set commands change the characteristics of routes, either adding something or specifying a level.
When there are multiple match commands with the same parameter under one instance of route-map, the system does a match
between all of those match commands. If there are multiple match commands with different parameters, the system does a
match ONLY if there is a match among ALL the match commands.
In the following example, there is a match if a route has any of the tag values specified in the match commands.
Example of the match Command to Match Any of Several Values
Dell(conf)#route-map force permit 10
Dell(config-route-map)#match tag 1000
Dell(config-route-map)#match tag 2000
Dell(config-route-map)#match tag 3000
In the next example, there is a match only if a route has both of the specified characteristics. In this example, there a match only
if the route has a tag value of 1000 and a metric value of 2000.
128
Access Control Lists (ACLs)