Administrator Guide

Command Modes
● CONF-DYNAMIC-AUTH
Usage
Information
● Duplicate packets are dropped within replay-protection-window period if packet has same source IP
address, source UDP port and identifier.
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
The following is a list of the Dell EMC Networking OS version history for this command.
Version Description
9.13(0.0) Introduced on the C9010, S3100, S3048–ON, S4048T-ON, S4048–ON, S5000,
S6010–ON, S6000–ON, S6100–ON, S6000, Z9100–ON, Z9500, FN-IOM, and
MXL.
terminate-session
Configure NAS to reject dot1x terminate-session requests from DAC.
Syntax
terminate-session
To drop the DM terminate-session requests from DAC, enter the no terminate-session command.
Defaults Enabled.
Command Modes
● CONF-DYNAMIC-AUTH
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
The following is a list of the Dell EMC Networking OS version history for this command.
Version Description
9.13(0.0) Introduced on the C9010, S3100, S3048–ON, S4048T-ON, S4048–ON, S5000,
S6010–ON, S6000–ON, S6100–ON, S6000, Z9100–ON, Z9500, FN-IOM, and
MXL.
TACACS+ Commands
The Dell Networking OS supports TACACS+ as an alternate method for login authentication.
debug tacacs+
To assist with troubleshooting, view TACACS+ transactions.
C9000 Series
Syntax
debug tacacs+
To disable debugging of TACACS+, use the no debug tacacs+ command.
Defaults Disabled.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Security 1537