Setup Guide

13908 packets, 1114396 bytes, 0 underruns
5555 64-byte pkts, 8213 over 64-byte pkts, 140 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
13727 Multicasts, 5 Broadcasts, 176 Unicasts
0 throttles, 0 discarded, 0 collisions, 0 wreddrops
Rate info (interval 150 seconds):
Input 300.00 Mbits/sec, 1534517 packets/sec, 30.00% of line-rate
Output 100.00 Mbits/sec, 4636111 packets/sec, 10.00% of line-rate
Time since last interface status change: 21:00:43
Dynamic Counters
By default, counting is enabled for IPFLOW, IPACL, L2ACL, L2FIB.
For the remaining applications, Dell EMC Networking OS automatically turns on counting when you enable the application, and is
turned off when you disable the application.
NOTE: If you enable more than four counter-dependent applications on a port pipe, there is an impact on line rate
performance.
The following counter-dependent applications are supported by Dell EMC Networking OS:
● Egress VLAN
● Ingress VLAN
● Next Hop 2
● Next Hop 1
● Egress ACLs
● ILM
● IP FLOW
● IP ACL
● IP FIB
● L2 ACL
● L2 FIB
Clearing Interface Counters
The counters in the show interfaces command are reset by the clear counters command. This command does not
clear the counters any SNMP program captures.
To clear the counters, use the following the command.
● Clear the counters used in the show interface commands for all VRRP groups, VLANs, and physical interfaces or
selected ones. Without an interface specified, the command clears all interface counters.
EXEC Privilege mode
clear counters [interface] [vrrp [vrid] | learning-limit]
(OPTIONAL) Enter the following interface keywords and slot/port or number information:
○ For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port/subport information.
○ For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the slot/port/subport information.
○ For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port/subport information.
○ For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the slot/port/subport information.
○ For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the slot/port information.
○ For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.
○ For the Management interface on the stack-unit, enter the keyword ManagementEthernet then the slot/port
information.
○ For a port channel interface, enter the keywords port-channel then a number.
○ For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
○ (OPTIONAL) To clear statistics for all VRRP groups configured, enter the keyword vrrp. Enter a number from 1 to 255
as the vrid.
○ (OPTIONAL) To clear unknown source address (SA) drop counters when you configure the MAC learning limit on the
interface, enter the keywords learning-limit.
Interfaces
401