Release Notes
Table Of Contents
- Dell EMC System S4048–ON 9.14(2.10) Release Notes
- Document Revision History
- Supported Hardware
- Supported Software
- New Dell EMC Networking OS Version 9.14(2.10) Features
- Restrictions
- Changes to Default Behavior and CLI Syntax
- Documentation Corrections
- Deferred Issues
- Fixed Issues
- Known Issues
- Upgrading the sub-components
- Upgrading ONIE on the S4048-ON
- Upgrading the S4048-ON Dell EMC Networking OS Image using the Dell EMC Networking OS CLI
- Installing Dell EMC Networking OS on the S4048-ON using ONIE
- Uninstalling Dell EMC Networking OS from the S4048-ON
- Support Resources
upgrade boot bootflash-image stack-unit [<id> | all] [booted | flash: | ftp: | scp: |
tftp: | usbflash:]
DellEMC#upgrade boot bootflash-image stack-unit 1 booted
Current Boot information in the system:
======================================================================
Card BootFlash Current Version New Version
----------------------------------------------------------------------
Unit1 Boot Flash 3.21.2.3 3.21.2.9
***********************************************************************
* Warning - Upgrading boot flash is inherently risky and should only *
* be attempted when necessary. A failure at this upgrade may cause *
* a board RMA. Proceed with caution ! *
***********************************************************************
Proceed upgrade Boot Flash image for stack-unit 1 [yes/no]: y
!!!!!
Bootflash image upgrade for stack-unit 1 completed successfully.
DellEMC#
Upgrade the CPLD
The S4048-ON system with Dell EMC Networking OS Version 9.14(2.10) requires System CPLD revision 15.2, Master CPLD
revision 12, and Slave CPLD revision 5.
NOTE:
If your CPLD revisions are higher than the ones shown here, DO NOT make any changes. If you have questions
regarding the CPLD revision, contact technical support.
Verify that a CPLD upgrade is required
Use the following command to identify the CPLD version:
DellEMC#show revision
-- Stack unit 1 --
S4048-ON SYSTEM CPLD : 15.2
S4048-ON MASTER CPLD : 12
S4048-ON SLAVE CPLD : 5
DellEMC#
Use the following command to view CPLD version that is associated with the Dell EMC Networking OS image:
DellEMC#show os-version
RELEASE IMAGE INFORMATION :
---------------------------------------------------------------------
Platform Version Size ReleaseTime
S-Series:SK-ON 9.14(2.10) 66927971 May 18 2021 00:43:07
TARGET IMAGE INFORMATION :
---------------------------------------------------------------------
Type Version Target checksum
runtime 9.14(2.10) Control Processor passed
BOOT IMAGE INFORMATION :
---------------------------------------------------------------------
Type Version Target checksum
boot flash 3.21.2.9 Control Processor passed
BOOTSEL IMAGE INFORMATION :
---------------------------------------------------------------------
9