Release Notes
Table Of Contents
- Dell EMC System S4048–ON 9.14(2.10) Release Notes
- Document Revision History
- Supported Hardware
- Supported Software
- New Dell EMC Networking OS Version 9.14(2.10) Features
- Restrictions
- Changes to Default Behavior and CLI Syntax
- Documentation Corrections
- Deferred Issues
- Fixed Issues
- Known Issues
- Upgrading the sub-components
- Upgrading ONIE on the S4048-ON
- Upgrading the S4048-ON Dell EMC Networking OS Image using the Dell EMC Networking OS CLI
- Installing Dell EMC Networking OS on the S4048-ON using ONIE
- Uninstalling Dell EMC Networking OS from the S4048-ON
- Support Resources
Supported Hardware
The following hardware is supported with this platform:
Table 2. Supported Hardware
Hardware
S4048-ON chassis
Forty eight SFP+ ports (10 Gbps)
Six QSFP+ ports (40 Gbps)
Two AC/DC PSUs
Three fan subsystems
One MicroUSB serial console port
One universal serial bus (USB Type-A) port for additional file storage
Management Ethernet interface
RS-232 Serial interface
Dual core 1.7GHz Rangeley central processing unit (CPU) system
NOTE: If all the three fan trays are found to be empty or faulty, the system shuts down after one minute.
Supported Software
The following software is supported with this platform:
Table 3. Supported Software
Software Minimum Release Requirement
Dell EMC Networking OS 9.14(2.10)
ONIE 3.21.1.0-5
NOTE: For information on non-Dell OS versions, refer the Release Notes for the Hardware Platform S4048–ON.
New Dell EMC Networking OS Version 9.14(2.10)
Features
The following features are integrated into the Dell EMC Networking 9.14.2 branch through this release:
None
Restrictions
● Prerequisite steps to upgrade the Dell EMC Networking OS from earlier version to 9.14.2.0 or later:
1. Uninstall the older version of the Open Automation (OA) package
2. Upgrade the Dell EMC Networking OS to 9.14.2.0 or later version
3. Install the 9.14.2.0 version or later of the OA packages :
a. SmartScripts
b. Puppet
2