Release Notes

Erasing internal mass storage device: /dev/sda7 (6578MB)
Percent complete: 100%
Erase complete.
Deleting partition 7 from /dev/sda
Installing for i386-pc platform.
Installation finished. No error reported.
Uninstall complete. Rebooting...
umount: can't remount rootfs read-only
The system is going down NOW!
Sent SIGTERM to all processes
Sent SIGKILL to all processes
Requesting system reboot
sd 4:0:0:0: [sda] Synchronizing SCSI cache
Restarting system.
machine restart
BIOS (Dell EMC) Boot Selector
S4000 3.21.0.0-6
(48-port SFP+ 10G/6-port QSFP 40G)
POST Configuration
CPU Signature 406D8
CPU FamilyID=6, Model=4D, SteppingId=8, Processor=0
Microcode Revision 125
POST Control=0xEA000303, Status=0xE6009700
Platform ID: 10041836
PMG_CST_CFG_CTL: 40006
BBL_CR_CTL3: 7E2801FF
Misc EN: 4000840081
Gen PM Con1: 3008
Therm Status: 8841000F
BIOS initializations...
CPGC Memtest for Channel 0 ..................... PASS
ECC enabled: channel 0 MayCCTRL_DUNIT_REG=0x000200F3
POST:
RTC Battery OK at last cold boot
RTC date Tue 05/18/2021 17:56:40
POST SPD test ............................... PASS
POST Lower DRAM Memory test
Short memory cell test
Perf cnt (curr/fixed): 321C074CD/32C553963
POST Lower DRAM Memory test ................. PASS
POST Lower DRAM ECC check ................... PASS
DxE POST
POST PCI test ............................... PASS
POST NVRAM check ............................ PASS
POST overall test results ................... PASS
NVRAM at POST exit: 00 97 00 E6 03 03 00 EA
5. After the installation completes, the system displays the following ONIE prompt:
ONIE:/ #
18