Release Notes
Table Of Contents
- Dell EMC System S4048–ON 9.14(2.10) Release Notes
- Document Revision History
- Supported Hardware
- Supported Software
- New Dell EMC Networking OS Version 9.14(2.10) Features
- Restrictions
- Changes to Default Behavior and CLI Syntax
- Documentation Corrections
- Deferred Issues
- Fixed Issues
- Known Issues
- Upgrading the sub-components
- Upgrading ONIE on the S4048-ON
- Upgrading the S4048-ON Dell EMC Networking OS Image using the Dell EMC Networking OS CLI
- Installing Dell EMC Networking OS on the S4048-ON using ONIE
- Uninstalling Dell EMC Networking OS from the S4048-ON
- Support Resources
POST Configuration
POST Configuration
CPU Signature 406D8
CPU FamilyID=6, Model=4D, SteppingId=8, Processor=0
Microcode Revision 125
Platform ID: 0x10041838
PMG_CST_CFG_CTL: 0x40006
BBL_CR_CTL3: 0x7E2801FF
Misc EN: 0x4000840081
Gen PM Con1: 0x203808
Therm Status: 0x8848000F
POST Control=0xEA000303, Status=0xE6009700
BIOS initializations...
CPGC Memtest for Channel 0 .................. PASS
ECC enabled: channel 0 MayCCTRL_DUNIT_REG=0x000200F3
POST:
RTC Battery OK at last cold boot
RTC date Tuesday 05/18/2021 9:21:08
POST SPD test ............................... PASS
POST Lower DRAM Memory test
.... Perf cnt (curr,fixed): 0x15A4A6B39,0x164D9BDB7
POST Lower DRAM Memory test ................. PASS
POST Lower DRAM ECC check ................... PASS
DxE POST
POST PCI test ............................... PASS
POST NVRAM check ............................ PASS
POST overall test results ................... PASS
NVRAM at POST exit: 00 97 00 E6 03 03 00 EA
Version 2.16.1242. Copyright (C) 2021 American Megatrends, Inc.
BIOS Date: 05/18/2021 16:20:37 Ver: 0ACBZ018
Press <DEL> or <F2> to enter setup.
Grub 1.99~rc1 (Dell EMC)
Built by root at ubuntu on Tue_May_18_14:16:54_UTC_2021
S4000 Boot Flash Label 3.21.2.9 NetBoot Label 3.21.2.9
Press Esc to stop autoboot ... 0
Primary Boot not Configured
5. After the installation completes, the system displays the following DELL prompt:
DellEMC>
Uninstalling Dell EMC Networking OS from the S4048-
ON
To uninstall the Dell EMC Networking OS version 9.14(2.10) from the S4048-ON device, perform the following steps:
1. Reboot the system. During the reboot process, the system displays the following message prompting you to press the Esc
key in order to stop the auto-boot process:
Version 2.17.1245. Copyright (C) 2021 American Megatrends, Inc.
BIOS Date: 05/18/2021 16:20:37 Ver: 0ACBZ038
16