Install Guide

● In stacking, configure profile first before provisioning for new units. Otherwise it is mandatory to reload for profile to take
effect.
● If there is a mismatch in fan-out profile between master and the new member in stacking, the master re-configures the
member with its quad-mode profile, quad-mode, and stack-group configuration and then reset the member. To avoid stack
split during profile mismatch, the master does stack group configurations of the new member.
To configure the quad-port-profile, use the following command:
CONFIGURATION mode
stack-unit stack-unit number slot slot-number port port-number portmode quad
The defaults ports are:
2,4,6,8,9,10,11,12,13,14,15,16,17,18,19,20,21,22,23,24,25,27,29,31
To display the Fan-out capability profile, use the following show command:
show system stack-unit stack-unit number quad-port-profile
Example of the
show Command
The following example shows the show system stack-unit stack-unit number quad-port-
profile command.
Dell#show system stack-unit 1 quad-port-profile
Configured fan out profile ports in stack-unit 1
Configured Activated
2 2
4 4
6 6
8 8
9 9
10 10
11 11
12 12
13 13
14 14
15 15
16 16
17 17
18 18
19 19
20 20
21 21
22 22
25 25
27 27
29 29
30 30
31 31
32 32
S6010-ON_1#show system stack-unit 1 quad-port-profile
Configured fan out profile ports in stack-unit 1
Configured Activated
2 2
4 4
6 6
8 8
9 9
10 10
11 11
12 12
13 13
14 14
15 15
16 16
17 17
18 18
19 19
20 20
21 21
Interfaces
381