Deployment Guide

brief (OPTIONAL) Enter the keyword brief to view a brief summary of the interfaces
and whether an IP address is assigned.
configured (OPTIONAL) Enter the keyword configured to display the physical interfaces
with non-default configurations only.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.11(0.0) Updated the command output to include the unicast reverse path forwarding
(uRPF) status.
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
8.1.1.2 Supported on the E-Series ExaScale E600i.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage
Information
The following describes the show ip interface command shown in the following example.
Lines Description
TenGigabitEther
net 0/0...
Displays the interface’s type, slot/port, and physical and line protocol status.
Internet
address...
States whether an IP address is assigned to the interface. If an IP address is
assigned, that address is displayed.
IP MTU is... Displays IP MTU value.
Inbound access... Displays the name of the configured incoming access list. If none is configured, the
phrase “not set” is displayed.
Proxy ARP... States whether proxy ARP is enabled on the interface.
Split horizon... States whether split horizon for RIP is enabled on the interface.
Poison Reverse... States whether poison for RIP is enabled on the interface.
ICMP redirects... States if ICMP redirects are sent.
ICMP
unreachables...
States if ICMP unreachable messages are sent.
Example
Dell# show ip interface tengigabitethernet 2
TenGigabitEthernet 2/0 is down, line protocol is down
Internet address is not set
IP MTU is 1500 bytes
Directed broadcast forwarding is disabled
Proxy ARP is enabled
934 IPv4 Routing