Deployment Guide

Version Description
8.3.10.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.1.1.0 Introduced on the E-Series ExaScale.
7.9.1.0 Introduced VRF on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage
Information
This command provides egress port information for a given IP flow. This information is useful in identifying
which interface the packet follows in the case of Port-channel and Equal Cost Multi Paths. Use
this command for routed packed only. For switched packets, use the show port-channel-flow
command.
The show ip flow command does not compute the egress port information when load-balance
mac hashing is also configured due to insufficient information (the egress MAC is not available).
S-Series produces the following error message: %Error: Unable to read IP route table.
Example
Dell#show ip flow interface Te 1/8 189.1.1.1 63.0.0.1 protocol tcp
source-port 7898 destination-port 8
flow: 189.1.1.1 63.0.0.1 protocol 6 7868 8976
Ingress interface:Te 1/20
Egress interface:Te 1/14 to 1.7.1.2[CAM hit 103710] unfragmented packet
Te 1/10 to 1.2.1.2[CAM hit 103710] fragmented packet
show ip interface
View IP-related information on all interfaces.
C9000 Series
Syntax
show ip interface [interface | brief] [linecard slot-id] [configured]
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or number information:
● For a Loopback interface, enter the keyword Loopback then a number from 0
to 16383.
● For the Management interface, enter the keyword ManagementEthernet
then zero (0).
● For the Null interface, enter the keyword null then zero (0).
● For a Port Channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a tunnel interface, enter the keyword tunnel then the tunnel interface
number. The range is from 1 to 16383.
● For a VLAN, enter the keyword vlan then a number from 1 to 4094.
linecard slot-id Enter the linecard slot-id parameters to specify the switch ports on a line
card. The range of slot IDs is from 0 to 2.
IPv4 Routing 933