Deployment Guide

Version Description
9.3(0.1) Introduced on the S6000.
Usage
Information
Route prefixes stored in the L3 host table are managed using ECMP next-hop forwarding.
A warning message is displayed after you enter the command stating that this setting takes effect
for existing routes only when IPv4 route prefixes are cleared from the LPM routing table (RTM). To
enable storage of IPv4 route prefixes in the LPM table, disable this setting by entering the no ipv4
unicast-host-route command.
Example
Dell(conf)#ipv4 unicast-host-route
Warning: Command will take effect for existing routes only when IPv4
route prefixes are cleared from RTM
Dell(conf)#no ipv4 unicast-host-route
load-balance
By default, the system uses an IP 4-tuple (IP SA, IP DA, Source Port, and Destination Port) to distribute IP traffic over members
of a Port Channel as well as equal-cost paths. To designate another method to balance traffic over Port Channel members, use
the load-balance command.
C9000 Series
Syntax
load-balance {ip-selection [dest-ip | source-ip]} | {mac [dest-mac |
source-dest-mac | source-mac]} | {tcp-udp | ingress-port [enable]}
To return to the default setting (IP 4-tuple), use the no load-balance {ip-selection [dest-
ip | source-ip]} | {mac [dest-mac | source-dest-mac | source-mac]} | {tcp-
udp | ingress-port [enable]}command.
Parameters
ip-selection
{dest-ip |
source-ip}
Enter the keywords to distribute IP traffic based on the following criteria:
● dest-ip — Uses destination IP address and destination port fields to hash.
The hashing mechanism returns a 3-bit index indicating which port the packet
should be forwarded.
● source-ip — Uses source IP address and source port fields to hash. The
hashing mechanism returns a 3-bit index indicating which port the packet
should be forwarded.
mac {dest-mac |
source-dest-mac
| source-mac}
Enter the keywords to distribute MAC traffic based on the following criteria:
● dest-mac — Uses the destination MAC address, VLAN, Ethertype, source
module ID and source port ID fields to hash. The hashing mechanism returns a
3-bit index indicating which port the packet should be forwarded.
● source-dest-mac — Uses the destination and source MAC address, VLAN,
Ethertype, source module ID and source port ID fields to hash. The hashing
mechanism returns a 3-bit index indicating which port the packet should be
forwarded.
● source-mac — Uses the source MAC address, VLAN, Ethertype, source
module ID and source port ID fields to hash. The hashing mechanism returns
a 3-bit index indicating which port the packet should be forwarded.
tcp-udp enable Enter the keywords to distribute traffic based on the following:
● enable — Takes the TCP/UDP source and destination ports into
consideration when doing hash computations. This option is enabled by default.
ingress-port
enable
Enter the keywords to distribute traffic based on the following:
● enable — Takes the source port into consideration when doing hash
computations. This option is disabled by default.
IPv4 Routing 923