Deployment Guide

Parameters
console 0 Enter the keyword console 0 to configure the console port. The console option
for the S-Series is <0-0>.
vty number Enter the keyword vty then a number from 0 to 9 to configure a virtual terminal
line for Telnet sessions. The system supports 10 Telnet sessions.
end-number (OPTIONAL) Enter a number from 1 to 9 as the last virtual terminal line to
configure. You can configure multiple lines at one time.
Defaults Not configured
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command
Usage
Information
You cannot delete a terminal connection.
Related
Commands
access-class — restricts the incoming connections to a particular IP address in an IP access control list
(ACL).
password — specifies a password for users on terminal lines.
logging coredump server
Configure the switch to move (upload) a core dump for an application or kernel crash to an external FTP server.
C9000 Series
Syntax
logging coredump server {ipv4-address | ipv6-address} username name
password [type] password
Parameters
{ ipv4-address |
ipv6-address }
Enter the server IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X).
name Enter a username to access the target server.
type Enter the password type:
● Enter 0 to enter an unencrypted password.
● Enter 7 to enter a password that has already been encrypted using a Type 7
hashing algorithm.
password Enter a password to access the target server.
86 Control and Monitoring