Deployment Guide

0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
0 packets, 0 bytes 0 underruns
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts 0 Unicasts
0 throttles, 0 discarded, 0 collisions 0 wredDrops
0 Green WredDrops 0 Yellow WredDrops, 0 Red WredDrops
Rate info (interval 15 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Related
Commands
show hardware hg-stats — displays traffic statistics from internal ports in a HiGig link bundle.
hg-link-bundle-monitor enable
Enable the monitoring of link utilization and traffic distribution in backplane HiGig link bundles/port channels on a line-card or
switch fabric module (SFM) NPU.
C9000 Series
Syntax
hg-link-bundle-monitor {sfm npu-id hg-port—channel hg-port—channel-id |
slot slot npuUnit npu-id hg-port—channel 0} enable
To disable HiGig link-bundle monitoring, use the no version of this command.
Parameters
sfm npu-id hg-
port-channel hg-
port-channel-id
Specify a HiGig port channel on a switch SFM (spine) NPU by entering the
keyword sfm and SFM NPU ID, then hg-port-channel and a HiGig port
channel ID. SFM NPU IDs are 0 to 1; SFM HiGig port-channel IDs are 0 to 10.
slot slot-id
npuUnit npu-id
hg-port-channel
0
Specify a HiGig port channel on a line-card (leaf) NPU by entering the keyword
slot and slot number, then npuUnit and line-card NPU ID, then hg-port-
channel 0. Line-card slot numbers are 0 to 11; line-card NPU ID is 0 . The HiGig
port-channel ID range is from 0 to 2.
enable Enable HiGig link-bundle monitoring.
Command Mode CONFIGURATION
Command
History
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
9.3.0.0 Introduced on the Z9000 switch.
Usage
Information
You can configure HiGig link bundle monitoring so that a system log message or an SNMP trap is
generated when traffic distribution in a bundle is uneven. The formula that determines uneven traffic
distribution is predefined.
796 Interfaces