Deployment Guide

Related
Commands
● interface — configures a physical interface on the switch.
● show ip interface — displays Layer 3 information about the interfaces.
● show interfaces — displays information on a specific physical interface or virtual interface.
● show interfaces transceiver — displays the physical status and operational status of an installed
transceiver. The output also displays the transceiver’s serial number.
show interfaces transceiver
Display the physical status and operational status of an installed transceiver. The output also displays the transceiver’s serial
number.
C9000 Series
Syntax
show interfaces [tengigabitethernet slot/port | fortyGigE slot/port |
peGigE pe-id/stack-unit/port | peTenGigE pe-id/stack-unit/port] transceiver
Parameters
tengigabitethern
et
For a 10G interface, enter the keyword tengigabitethernet then the slot/port
(ports or port range) information.
fortyGigE For a 40G interface, enter the keyword fortyGigE then the slot/port (ports or
port-range)information.
peGigE For a port extender Gigabit Ethernet interface, enter the keyword peGigE then
the pe-id / stack-unit / port-id information. The pe-id range is from 0 to 255; the
stack-unit unit-number range is from 0 to 7; and the port-id range is from 1 to 48.
NOTE: The peGigE or peTenGigE option is only visible when the feature
extended bridge feature is enabled.
peTenGigE For a port extender 10-Gigabit Ethernet interface, enter the keyword peTenGigE
then the pe-id / stack-unit / port-id information. The pe-id range is from 0 to 255;
the stack-unit unit-number range is from 0 to 7; and the port-id range is 25 to 28
or 49 to 52 depending on the PE.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.13.0.1P1 Introduced peTenGigE interface support on the C9010.
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Output augmented with diagnostic data for pluggable media.
7.7.1.0 Removed three fields in the output: Vendor Name, Vendor OUI, and Vendor PN.
7.6.1.0 Introduced on the C-Series and S-Series.
6.5.4.0 Introduced on the E-Series.
Interfaces 767