Deployment Guide

Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.2.1.0 Added support for 4093 VLANs on E-Series ExaScale. Prior releases supported
2094.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage
Information
When creating an interface range, interfaces appear in the order they are entered; they are not sorted.
The command verifies that interfaces are present (physical) or configured (logical).
Important Points to Remember:
● Bulk configuration is created if at least one interface is valid.
● Non-existing interfaces are excluded from the bulk configuration with a warning message.
● The interface range prompt includes interface types with slot/port information for valid
interfaces. The prompt allows for a maximum of 32 characters. If the bulk configuration exceeds
32 characters, it is represented by an ellipsis ( ... ).
● For PE ports, the interface range prompt includes interface type with pe-id / stack-unit /
port-id.
●
When the interface range prompt has multiple port ranges, the smaller port range is excluded
from the prompt.
● If overlapping port ranges are specified, the port range is extended to the smallest start port and the
biggest end port.
Example (Bulk)
Dell EMC(conf)# interface range te 10/0, fo 0/0, te 2/0
% Warning: Non-existing ports (not configured) are ignored by
interface-range
Example
(Multiple Ports)
Dell EMC(conf)# interface range te 2/0 - 23, te 2/1 - 10
Dell(conf-if-range-te-2/0-23#
Example
(Overlapping
Ports)
Dell EMC(conf)# interface range te 2/1 - 11, te 2/1 - 23
Dell(conf-if-range-te-2/1-23#
Example (If
atleast one port
is configured)
DellEMC(conf)# interface range tengigbitethernet 2/1 - 11,
tengigbitethernet 2/1 - 23
% Warning: Non-existing ports (not configured) are ignored by
interface-range
Example (If
no ports are
configured within
the specified
interface range)
DellEMC(conf)# interface range tengigbitethernet 2/0 - 23, fortyGigE
0/0, tengigbitethernet 2/0
% Error: No port is configured in interface range
Usage
Information
Only VLAN and port-channel interfaces created using the interface vlan and interface port-
channel commands can be used in the interface range command.
Use the show running-config command to display the VLAN and port-channel interfaces. VLAN
or port-channel interfaces that are not displayed in the show running-config command cannot be
722 Interfaces