Deployment Guide

action={act=EtagNew, param0=65772(0x100ec), param1=0(0), param2=0(0),
param3=0(0)}
policer=
statistics=NULL
EID 0x00000bff: gid=0x5,
slice=6, slice_idx=0x1, part =0 prio=0xbff, flags=0x10202, Installed,
Enabled
tcam: color_indep=0,
Stage
InPort
DATA=0x0000000000000000000000000000000000000000000000001000000000
MASK=0x00000000000000000000000000000000000000000000fdffffffffffff
InPorts
DATA=0x0000000000000000000000000000000000000000000000001000000000
MASK=0x00000000000000000000000000000000000000000000fdffffffffffff
HiGig
Offset: 320 Width: 1
DATA=0x00000000
MASK=0x00000001
SrcMac
Offset: 89 Width: 48
DATA=0x00000000 08000100
MASK=0x0000ffff ffffffff
action={act=DropCancel, param0=0(0), param1=0(0), param2=0(0),
param3=0(0)}
policer=
statistics=NULL
show hardware system-flow
This command displays hardware system-flow information.
C9000 Series
Syntax
show hardware system-flow {cp-switch | linecard slot-id port-set port
number | pe pe-id stack-unit unit–number port-set port-pipe-id } counters
Parameters
cp-switch Enter the keyword cp-switch to display the counters for control traffic on the
control plane.
linecard slot-id Enter the linecard slot-id parameters to identify the line card on which you
want to clear system-flow statistics. The range of slot IDs is from 0 to 11.
pe peid Enter the keyword pe and the port extender (PE) ID to display the counters for a
specified PE. The PE ID ranges is from 0 to 255.
NOTE: The pe option is only visible when the extended bridge feature is
enabled.
stack-unit unit-
number
Enter the keyword stack-unit and unit number to display the counters for the
specified stack-unit. The stack unit range is from 0 to 7.
port set port-
pipe
Enter the keyword port-set and port-pipe number. The port-set number is 0.
Defaults none
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Debugging and Diagnostics 611