Deployment Guide

DATA=0x0000000000000000000000000000000000000000000000000000000000000004
MASK=0x00000000000000000000000000000000000000000000000000fdffffffffffff
InPorts
DATA=0x0000000000000000000000000000000000000000000000000000000000000004
MASK=0x00000000000000000000000000000000000000000000000000fdffffffffffff
HiGig
Offset: 320 Width: 1
DATA=0x00000000
MASK=0x00000001
Stage
IpFrag
Offset: 71 Width: 2
DATA=0x00000001
MASK=0x00000001
action={act=CopyToCpuCancel, param0=0(0), param1=0(0),
param2=0(0), param3=0(0)}
action={act=EtagNew, param0=327687(0x50007), param1=0(0),
param2=0(0), param3=0(0)}
policer=
statistics={stat id 167 slice = 6 idx=0 entries=1}{Packets}
show hardware ipv6
Display information about IPv6 ACLs used on a line card and port pipe.
C9000 Series
Syntax
show hardware ipv6 {eg-acl | in-acl} linecard slot-id port-set port-pipe
Parameters
eg-acl | in-acl Enter either the keyword eg-acl or the keyword in-acl to display ingress or
egress ACL data.
linecard slot-id Enter the linecard slot-id parameters to specify a line card on the switch.
The range of slot IDs is from 0 to 2.
port-set port-
pipe
Enter the keywords port-set port-pipe parameters to specify a port pipe
(set of ports) on a line card. The range of port-pipe numbers is: 0 to 2 on line card
0 and 0 to 3 on line cards 1 and 2.
Defaults none
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
608 Debugging and Diagnostics