Deployment Guide

Total Ports: 4001
Example
An ACL rule with a TCP port lt 1023 uses only one entry in the CAM.
Rule# Data Mask From To #Covered
1 0000000000000000 1111110000000000 0 1023 1024
Total Ports: 1024
Related
Commands
ip access-list extended — creates an extended ACL.
permit — assigns a permit filter for IP packets.
permit tcp — assigns a permit filter for TCP packets.
resequence prefix-list ipv4
Re-assign sequence numbers to entries of an existing prefix list.
C9000 Series
Syntax
resequence prefix-list ipv4 {prefix-list-name StartingSeqNum Step-to-
increment}
Parameters
prefix-list-name Enter the name of the configured prefix list, up to 140 characters long.
StartingSeqNum Enter the starting sequence number to resequence. The range is from 0 to 65535.
Step-to-
Increment
Enter the step to increment the sequence number. The range is from 1 to 65535.
Defaults none
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale
7.8.1.0 Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, names
were up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Usage
Information
When you have exhausted all the sequence numbers, this feature permits re-assigning a new sequence
number to entries of an existing prefix list.
Related
Commands
resequence access-list— resequences an access-list.
Access Control Lists (ACL) 251