Deployment Guide

the stack-unit unit-number range is from 0 to 7; and the port-id range is from 1
to 48.
● For a port extender 10-Gigabit Ethernet interface, enter the keyword
peTenGigE then the pe-id / stack-unit / port-id information. The pe-id range
is from 0 to 255; the stack-unit unit-number range is from 0 to 7; and the
port-id range is 25 to 28 or 49 to 52 depending on the PE.
in Enter the keyword in to display information for an ip ingress or inbound access-list
attached to an interface.
out Enter the keyword out to display information for an ip egress or outbound access-
list attached to an interface.
Defaults None
Command Modes EXEC
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.13.0.1P1 Introduced peTenGigE interface support on the C9010.
9.9(0.0) Introduced on the C9010.
Usage
Information
If you do not attach an ingress or egress access-list to an interface, no information displays and you
return to the DELL# prompt.
Example
Dell# show ip access-lists out
Standard Egress IP access list first
seq 5 permit any count bytes (0 bytes)
seq 10 deny any count (0 packets)
Standard Egress IP access list five
seq 5 permit any
Standard Egress IP access list four
seq 5 permit any count bytes (0 bytes)
seq 10 deny any count (0 packets)
Standard Egress IP access list second
seq 5 permit host 1.1.1.1 count bytes (0 bytes)
Extended Egress IP access list ten
seq 5 permit tcp any eq 1 any
seq 10 deny ip any host 11.11.11.11 count (0 packets)
Extended IP ACL Commands
The following commands configure extended IP ACLs, which in addition to the IP address, also examine the packet’s protocol
type.
The C9000 supports both Ingress and Egress IP ACLs.
When an ACL is created without any rule and then applied to an interface, ACL behavior reflects an implicit permit.
NOTE: Also refer to the Commands Common to all ACL Types and Common IP ACL Commands sections.
232 Access Control Lists (ACL)