Deployment Guide

state Enter the keyword state to enable debugging of VRRP state changes
timer Enter the keyword timer to enable debugging of the VRRP timer.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
8.3.19.0 Introduced on the S4820T.
8.3.10.0 Introduced on the S4810.
8.4.1.0 Introduced on E-Series ExaScale, C-Series, and S-Series. Support was added for
IPv6 VRRP groups in non-default VRF instances.
8.3.2.0 Introduced on the E-Series TeraScale.
Usage
Information
If no options are specified, debug is active on all interfaces and all VRRP groups.
show vrrp ipv6
View the IPv6 VRRP groups that are active. If no VRRP groups are active, the Dell Networking OS returns No Active VRRP
group.
C9000 Series
Syntax
show vrrp ipv6 [vrid] [interface] [brief][vrf vrf-name]
Parameters
vrid (OPTIONAL) Enter the virtual router identifier for the VRRP group to view only
that group. The range is from 1 to 255.
interface Enter the following keywords and slot/port or number information:
● For a Port Channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a VLAN interface, enter the keyword vlan then the VLAN ID. The VLAN ID
range is from 1 to 4094.
brief (OPTIONAL) Enter the keyword brief to view a table of information on the VRRP
groups.
vrf vrf-name Enter the keyword vrf followed by the name of the VRF to view IPv6 VRRP groups
corresponding to that VRF.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
1768 Virtual Router Redundancy Protocol (VRRP)