Deployment Guide

● For SONET interfaces, enter the keyword sonet followed by the slot/port
information.
● For a 40-Gigabit Ethernet interface, enter the keyword FortyGigE followed
by the slot/port information.
● For a tunnel interface, enter the keyword tunnel followed by the slot/port
information.
● For a VLAN interface, enter the keyword vlan followed by the VLAN ID. The
VLAN ID range is from 1 to 4094.
● For a port extender (PE) Gigabit Ethernet interface, enter the keyword peGigE
followed by the pe-id /stack-unit unit number / port-ID number.
● For a port extender 10-Gigabit Ethernet interface, enter the keyword
peTenGigE then the pe-id / stack-unit / port-id information. The pe-id range
is from 0 to 255; the stack-unit unit-number range is from 0 to 7; and the
port-id range is 25 to 28 or 49 to 52 depending on the PE.
priority-cost (OPTIONAL) Enter a number as the amount to be subtracted from the priority
value. The range is 1 to 254. The default is 10.
Defaults priority cost = 10
Command Modes VRRP
Command
History
Version Description
9.13.0.1P1 Introduced peTenGigE interface support on the C9010.
9.9(0.0) Introduced on the C9010.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2.(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
7.6.1.0 Introduced on the S-Series (S50 only).
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage
Information
If the interface is disabled, the cost value is subtracted from the priority value and forces a new MASTER
election if the priority value is lower than the priority value in the BACKUP virtual routers.
IPv6 VRRP Commands
The following are IPv6 VRRP commands.
● clear counters vrrp ipv6
● debug vrrp ipv6
● show vrrp ipv6
● vrrp-ipv6-group
The following commands apply to IPv4 and IPv6:
● advertise-interval
● clear counters vrrp ipv6
● description
● disable
● hold-time
● preempt
● priority
● show config
● virtual-address
1766
Virtual Router Redundancy Protocol (VRRP)