Deployment Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

1761

Table Of Contents

Defaults Not configured.

Command Modes VRRP

Command

History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.9(0.0) Introduced on the C9010.

9.2(1.0) Introduced on the Z9500.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

7.4.1.0 Introduced support for telnetting to the VRRP group IP address assigned using this

command.

6.2.1.1 Introduced on the E-Series.

Usage

Information

The VRRP group only becomes active and sends VRRP packets when a virtual IP address is configured.

When you delete the virtual address, the VRRP group stops sending VRRP packets.

A system message appears after you enter or delete the virtual-address command.

To guarantee that a VRRP group becomes MASTER, configure the VRRP group’s virtual address with the

same IP address as the interface’s primary IP address and change the priority of the VRRP group to 255.

You can ping the virtual addresses configured in all VRRP groups.

vrrp delay minimum

Set the delay time for VRRP initialization after an interface comes up.

C9000 Series

Syntax

vrrp delay minimum seconds

Parameters

seconds

Enter the number of seconds for the delay for VRRP initialization after an interface

becomes operational. The range is from 0 to 900 (0 indicates no delay).

Defaults 0

Command Modes INTERFACE