Deployment Guide

When restoring factory default settings, a switch remains in standalone mode after the restoration. After
the restore is complete, the units power cycle immediately.
CAUTION: There is no undo for this command.
Example
Dell#restore factory-defaults chassis clear-all
***********************************************************************
* Warning - Restoring factory defaults will delete the existing
*
* startup-config and resets all persistent settings (stacking,
*
* fanout, etc.) and boot environment variables (boot config,
console *
* baud rate, management interface settings, etc.)
*
* After restoration the unit(s) will be powercycled immediately.
*
* Proceed with caution !
*
***********************************************************************
Proceed with factory settings? Confirm [yes/no]:
rmdir
Remove a directory from the NFS mounted file system.
C9000 Series
Syntax
rmdir nfsmount://mount-point/usrname
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010 Series.
9.7(0.0) Introduced this command.
Example
Dell#rmdir nfsmount:/nfs-mountpoint/guest
Proceed to remove the directory [confirm yes/no]: yes
Dell#
Related
Commands
mkdir – creates a directory.
176 File Management