Deployment Guide

The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Related
Commands
logging trap — limit messages logged to the Syslog servers based on severity.
logging
Configure an IP address or host name of a Syslog server where logging messages are sent. Multiple logging servers of both IPv4
and/or IPv6 can be configured.
C9000 Series
Syntax
logging {ip-address | ipv6-address | hostname} {{vrf management}{udp
{port}} | {tcp {port}}
To disable logging, use the no logging {ip-address | ipv6-address | hostname} {{vrf
management} | {udp {port}} | {tcp {port}} command.
Parameters
ip-address Enter the IPv4 address in dotted decimal format.
ipv6-address Enter the IPv6 address in the x:x:x:x::X format.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
hostname Enter the name of a host already configured and recognized by the switch.
management Management VRF name to be used to reach host.
udp Enter the keyword udp to enable transmission of log message over UDP followed
by port number. The default port is 514
tcp Enter the keyword tcp to enable transmission of log message over TCP followed
by port number.
Defaults Disabled.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.x.x.x Introduced on the C9000.
9.5(0.1) Added udp and tcp keywords for the Z9500.
9.5(0.0) Added udp and tcp keywords for the S4810, S4820T, S6000, Z9000, and MXL.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
Simple Network Management Protocol (SNMP) and Syslog 1627