Deployment Guide

● If an 802.1X port is authenticated and put in the RADIUS server assigned VLAN, any change to the port access VLAN
configuration does not take effect.
● The 802.1X with VLAN assignment feature is not supported on trunk ports, dynamic ports, or with dynamic-access port
assignment through a VLAN membership.
dot1x authentication (Configuration)
Enable dot1x globally. Enable dot1x both globally and at the interface level.
C9000 Series
Syntax
dot1x authentication
To disable dot1x globally, use the no dot1x authentication command.
Defaults Disabled
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
7.6.1.0 Introduced on the C-Series and S-Series.
7.4.1.0 Introduced on the E-Series TeraScale.
Related
Commands
dot1x authentication (Interface)
dot1x authentication (Interface)
Enable dot1x on an interface; dot1x must be enabled both globally and at the interface level.
C9000 Series
Syntax
dot1x authentication
To disable dot1x on an interface, use the no dot1x authentication command.
Defaults Disabled.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1540 Security