Deployment Guide

show config
Display the PE provision configuration details.
C9000 Series
Syntax
show config
Command Modes PE CONFIG (conf-pe-pe-id)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
Example
Dell(conf-pe-5)# show config
!
pe provision 5
stack-unit 4 type C1048P
Dell(conf)#pe 255
Dell(conf-pe-255)#show config
!
pe provision 255
cascade interface TenGigabitEthernet 6/0
stack-unit 1 type C1048P
show ecid
Display the E-Channel identifier (ECID) information for all or any specified interfaces.
C9000 Series
Syntax
show ecid {interface [interface] | pe pe-id stack—unit unit-number}
Parameters
interface
interface
Enter the interface keyword, and specify one of the following interface types:
● For a PE Gigabit Ethernet interface, enter the keyword peGigE. You must
specify a pe-id/stack-unit/port-id for the interface.
● For a port extender 10-Gigabit Ethernet interface, enter the keyword
peTenGigE then the pe-id / stack-unit / port-id information. The pe-id range
is from 0 to 255; the stack-unit unit-number range is from 0 to 7; and the
port-id range is 25 to 28 or 49 to 52 depending on the PE.
● For a port channel interface, enter the keyword port-channel
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
pe pe-id Enter the keyword pe keyword and specify a port extender ID number. Range is
from 0 to 255.
stack-unit unit-
number
Enter the keyword stack-unit and the unit number. Range is from 0 to 7.
Default
None
1346 Port Extenders (PE)