Deployment Guide

reset pe schedule
Configure the PEs to reset or reboot at a specified period of time.
Syntax
reset pe schedule {after HHHH:MMMM | at [HHHH:MMMM-DD:MM:YR | HHHH:MMMM]}
{range pe-id-pe-id}
Defaults None.
Parameters
after
HHHH:MMMM
Enter the keyword after followed by the amount of time in hours and minutes
after which the PEs should reboot.
at HHHH:MMMM Enter the keyword at followed by the exact time on the current date at which the
PEs should reboot.
at
HHHH:MMMM-
DD:MM:YR
Enter the keyword at followed by the exact date and time at which the PEs should
reboot.
range pe-id-pe-id Enter the keyword range followed by the range of pe-ids that you want to
schedule to reboot. The range is from 0 to 255.
Command Modes
● EXEC Privilege
Usage
Information
● You can schedule a PE to reboot after a particular amount of time, in hours and minutes (HH:MM),
from the current time. For example, you can schedule a PE to reset 10 minutes from the current time
using the following command: reset pe schedule after 0:10 range 10-20.
● You can schedule a PE to reset exactly at the specific date and time. For example, you can schedule
a PE to reset at a 0:10 PM on 29th November 2017 using the following command: reset pe
schedule at 0:10-11/29/17 range 10-20.
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.13(0.0) Introduced on the C9010.
reset pe range
Specify a range of port extenders (PEs) that you want to schedule for rebooting at a later point of time.
Syntax
reset pe range {pe-id-pe-id | pe-id1,pe-id2,.......} {no-confirm}
Defaults None.
Parameters
pe-id-pe-id Enter the range of port extender IDs that you want to schedule for rebooting.
pe-id1,pe-
id2,...........
Enter a list of port extender IDs that you want to schedule for rebooting with each
pe-id delimited by a coma.
no-confirm Enter the keyword no-confirm to suppress the warning messages that are
displayed during rebooting of the PE.
Command Modes
● EXEC Privilege
Usage
Information
● The reset pe range command is applicable for the entire PE stack-unit. This command is not used
for per stack-unit scenario.
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1344 Port Extenders (PE)