Deployment Guide

Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage
Information
CAUTION: Use this command only when you are working directly with a technical support
representative to troubleshoot a problem. Do not use this command unless a technical
support representative instructs you to do so.
show cpu-traffic-stats
View CPU traffic statistics.
C9000 Series
Syntax
show cpu-traffic-stats [cp | rp | linecard {slot-id | pe ]
Parameters
number Specify an interface number. The number of interfaces range from 1 to 1568.
all Enter the keyword all to display traffic statistics on all the interfaces.
cp Enter the keyword cp to display traffic statistics on the Control Processor CPU.
rp Enter the keyword rp to display traffic statistics on the Route Processor CPU.
pe Enter the keyword pe to display traffic statistics on the Port Extender.
Defaults Display CPU traffic statistics for all switch CPUs (Control Processor and Route Processor).
Command Modes EXEC
Example
Dell#show cpu-traffic-stats
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series
102 Control and Monitoring